Hot Dipped Collar Damper Series

Product NameHot Dipped Collar Damper Series
MaterialPlastic,ABS,PVC or other material
ColorWhite or custom color
StandardChina standard
SizeCustomized
MOQ10
PackagingStandard packaging
Delivery30day
  • Dead End Grip, Preformed Guy Grip Dead End Manufacturer

    Dead end grip. The material that manufacturers use in making the dead-end grips are the same as the material of the strand. The design is intended for single use, but for retention purposes, it is used twice within a 90-day window of installation.

    Ask For Quote Details
  • Hot Blast 1551E

    The old one has the small gear and the loose collar like piece where the arm goes in to be tightened by the set screw, the new one has the bigger gear and solid polished snout where the arm attaches.Just purchased a Hot Blast 1551E stove.Even when the temps dipped to -31 it was still 70 plus inside with out help from the LP furnace

    Ask For Quote Details
  • Lindab

    The damper is made of hot-dip galvanized sheet steel. Installation. Consider required straight distance after or before disturbance, as mentioned on the card attached to the measurement nozzles, to obtain accurate flow measurement. Cleaning. By fully open the damper, one get access to the duct. Do not forget to readjust the damper after cleaning.

    Ask For Quote Details
  • 1700AA Series Asymmetrical Damper

    1700AA Series Asymmetrical Dampers Scope This is a summary of design and testing for the new 1700AA asymmetrical series of stockbridge dampers being offered by AFL for overhead transmission lines. The 1700AA series is intended to be used as an equivalent to the current 1700 series of dampers. As shown below, the

    Ask For Quote Details
  • Polyvinyl Ducts for HVAC | Underground Ductwork | PCD

    The PCD manufacturing process begins with (1) prime, hot-dipped, G-90 galvanized steel that is cleaned and fire-treated. Then (2) a special epoxy primer is bonded to both sides of the metal. Finally (3) a 4-mil polyvinyl coating is heat-fused to one side (4 x 1) or both sides (4 x 4).

    Ask For Quote Details
  • Lindab

    The damper is made of hot-dip galvanized sheet steel. Installation. Consider required straight distance after or before disturbance, as mentioned on the card attached to the measurement nozzles, to obtain accurate flow measurement. Cleaning. By fully open the damper, one get access to the duct. Do not forget to readjust the damper after cleaning.

    Ask For Quote Details
  • Machine | Bolts | Fasteners | Power & Utilities | Products

    Hex head machine bolt, 1/2" dia. x 1 3/4" long with 1 1/4" thead. Includes one hex nut. Rated tensile strength is 7,800 lbs. Galvanized per ASTM A-153.

    Ask For Quote Details
  • Vibration Damper Price, 2021 Vibration Damper Price

    Vibration Damper Price - Select 2021 high quality Vibration Damper Price products in best price from certified Chinese Rubber Vibration Damper manufacturers, Vibration Damper Pulley suppliers, wholesalers and factory on Made-in-China.com

    Ask For Quote Details
  • Accessories | Navien

    Allows for combined space heating and domestic hot water when paired with a recirculation pump (ComfortFlow™ on NPE-A).Designed to work with NFB-C series units for infield assembly and approved for indoor installations(30022799A) Includes cascade cable (GXXX000546) and common vent collar damper. 1 year warranty from date of purchase

    Ask For Quote Details
  • In Contact with Other Metals | American Galvanizers

    The following information provides more detail on other common metals used in construction that may come in contact with hot-dip galvanized steel. Copper and Brass. If an installation requires contact between galvanized materials and copper or brass in a moist or humid environment, rapid corrosion of the zinc may occur.

    Ask For Quote Details
  • Upset Bolt, Single/Double Upset Spool Bolt Manufacturer

    Upset Bolt. The upset bolt is a type of fastener designed for the spool insulator, it is assembled on one side-pole to support the neutral conductors or power wire.Upset bolt is also called upset spool bolt or bolt upset. There are two types of upset bolts, single upset bolts and double upset bolts.

    Ask For Quote Details
  • EFD 12 Damper + TF24 motor

    The outdoor/exhaust air damper prevents the hot water coil from freezing. The EFD consists of a tubular housing equipped with a damper blade pivoting on an axle. The connection ends are equipped with silicon rubber sealing rings. The damper is made from hot-dip galvanized sheet steel.

    Ask For Quote Details
  • Galvanized gas cap Home Hardware | Bizrate

    The RV series offers round gas vent pipe and fittings for residential, commercial andin. OWT timber screws Hot dipped galvanized steel Powder coated Corrosion resistant

    Ask For Quote Details
  • Base & Cap Hardware at Lowes.com

    Simpson Strong-Tie 4-in x 4-in Hot-dipped Galvanized Wood To Concrete (Cast In Place) Base. Post and column bases secure the bottom of posts or columns to concrete and are perfect for decks or patio covers. Models are available for attaching to existing hardened concrete, wet concrete, as well as wood.

    Ask For Quote Details
  • GTS | 16" Adhesive Starting Collar, No Damper

    Sheet Metal Duct Takeoff; Type Adhesive, Round; Size A 16 Inch Diameter; Size B 16 Inch Diameter; Material Thickness 28 Gauge; Material ASTM A653 CS Type B Hot Dip Galvanized Steel; Applicable Standard ASHRAE, HARDI, ADI, NHRAW; Tube Length 6 Inch; Flange Size 1-1/2 Inch

    Ask For Quote Details
  • MAX Series

    Install the Backdraft Damper with the leaf hinge vertical. The damper is installed on the “Stale Air to Outside Collar” 5 . Forced Air . Furnace . Cool Air . Return . Dampers for . balancing . airflows . Outdoors . RETURN AIR . EXHAUST AIR from various parts of home. i.e. bathrooms (if required), kitchens (if required) 3 ft min. recommended

    Ask For Quote Details
  • TK Products Pro

    TK Products 3-sided kennels are designed to be placed against a wall. Available in 18 different sizes and number of runs, all are 6 ft tall. Each kennel comes with everything needed to assemble and use. Superior "quiet" construction lasts longer with no sharp edges keeping your animals safe. Comes with a 5-year warranty and free shipping

    Ask For Quote Details
  • Galvanized Ductwork | Stainless Steel & Galvanized Duct

    The process of hot-dip galvanizing results in a metallurgical bond between zinc and steel with a series of distinct iron-zinc alloys, creating a versatile and affordable material for manufacturing ductwork and duct components. The resulting coated steel can be used in much the same way as uncoated.

    Ask For Quote Details
  • MAX SERIES

    Spring-Loaded Backdraft Damper (Recommended) There is a location for an optional Backdraft Damper with the leaf hinge vertical. The damper is installed on the “Stale Air to Outside Collar” Outdoors . Dampers for . balancing . airflows . Stale air from various parts of home. i.e. bathrooms (if required) kitchens (if required) Fresh air to house:

    Ask For Quote Details
  • Air Duct 14" Start Collar with Gasket, Damper & Standoff

    #714-DSO 14" START COLLAR W/GASKET, DAMPER & STAND-OFF 10/CTN. Page Loading Part Description: Start Collar with Gasket Flange, Manual Volume Damper and Damper Handle StandoffASTM A653 CS Type B Hot Dipped Galvanized Steel: Series/Model: Model 714-DSO: Size: 14 Inch: Victor part number: 9682: Resources Catalog Page(s) Crown Products Website

    Ask For Quote Details
  • Southwark Metal | HVACLove.com

    16" x 10", Hot Dip Galvanized Steel, Straight Pattern, Rectangular, Sheet Metal Trunk Duct Starting Collar

    Ask For Quote Details


Our Location

Contact Us

Boda Aluminum Products Co.,LTD

Address: Jingjiang, Taizhou City
Jiangsu Province, China
Zip code - 214500
Telephone: +86 18262317598
E-mail: [email protected]